HI all,
I set my geometry last year with a 4 wheel laser alignment system (mates garage) to the following specifications -
2mm Toe out (total)
-1.0° Camber both sides
CASTER - 3.5° each side
I needed new wheels and choose Mambas with - 7 ET, obviously i knew that i will have to remove some body at the front of the wheel arch to prevent rubbing.
The picture is of my new mambas trial fitted and does the wheel look to be in the right position for the correct camber above?
It is not in the middle of the wheel arch, it sits a bit forward of centre of the wheel arch.
So my question is -
Does the wheel position look normal/correct for correct caster??
I just want to check before a cut away the front of the wheel arch for clearance.
Thanks