Battery Going Flat
#1
Posted 03 August 2024 - 05:22 PM
I'm just looking for a couple of ideas.
I put my accumate on it without disconnecting the battery. 48 hours later it was still charging. So I disconnected the battery and it was charged in 20 minutes.
So the drain is constant and more than the charger puts out. That must be something quite heavy draw to do that. Even a short
I'm thinking just put a kill switch on it. On the positive side so that if there is a short somewhere it will stop that until it needs to be run
#2
Posted 03 August 2024 - 05:36 PM
Perhaps it was nearly charged. Disconnect the battery, if it still goes flat it can only be an internal fault. If it is on the digger it sounds bad enough to need finding & fixing.
#3
Posted 03 August 2024 - 07:42 PM
#4
Posted 03 August 2024 - 07:46 PM
More earthstraps the better I would say.. not going to do it any harm.
Under engine steady near to master cylinders in right hand drive cars...
Also added one to the Front panel mount. Onto the bell housing bolts.
Worth a try before major headaches start....
Would also check the positive from the boot to the solenoid... seen these melt to exhausts and cause issues you describe. .
#5
Posted 03 August 2024 - 07:55 PM
It's on the JCB at work but same principles apply. I tested the earth and its got 0 resistanceBefore you get stuck into doing things as above.. check your engine earth strap. Add one ( or two) and make sure you have a really good connection.
More earthstraps the better I would say.. not going to do it any harm.
Under engine steady near to master cylinders in right hand drive cars...
Also added one to the Front panel mount. Onto the bell housing bolts.
Worth a try before major headaches start....
Would also check the positive from the boot to the solenoid... seen these melt to exhausts and cause issues you describe. .
#6
Posted 03 August 2024 - 09:55 PM
Edited by 68+86auto, 03 August 2024 - 09:55 PM.
#7
Posted 04 August 2024 - 05:45 AM
Yep will do. There is a box on the positive post with about 5 wires coming off it. I will test each of those individuallyWe can't really help remotely other than throwing guesses at you as to what the load might be. Measure the voltage drop across all the fuses to try and find the load. I would put a clamp meter on a battery lead.
#8
Posted 04 August 2024 - 09:53 AM
-12 V 90Ah 820A EN
-315x175x175 mm
Very strong battery with two years warranty.
#9
Posted 05 August 2024 - 10:23 AM
if there is a draw that large the battery lead will spark when attached, connect a digital meter in line with the battery lead, not parallel and this should read 0amps with all off. if above this repaet on feeds from live post to find the draw. meters are usually fused at 10A so if greater will just blow internal fuse
#10
Posted 05 August 2024 - 04:42 PM
Take it to an auto electrician before you set fire to the car
1 user(s) are reading this topic
0 members, 1 guests, 0 anonymous users











