7 replies to this topic

[siaugary]

Hello,

 

To change my A panel I need to get to the spot welds. Is the trim that is over the two edges welded or just clamped?

Is this also original? 

 

Thanks 

Attached Files

•  487395882_690478100092766_9075584045415629475_n.jpg   21.45K   1 downloads
•  486682132_1599861313981529_943376574477376221_n.jpg   19.32K   1 downloads
•  486571484_643359888322226_3429669324380432666_n.jpg   21.39K   0 downloads

[gaspen]

Normally they fitted them with clamps only.

[Stevie W]

The trims are usually pushed onto clips that grip the welded seam and the trim strip itself. In reality they should be able to be levered off so you can gain access to the spot welds.

 

Cheers, Steve 

[Tupers]

They’re held on by a handful of these barbed clips and probably a fair bit of rust. https://www.minispar...m-moulding-clip

You can normally pry them up with a flat head screwdriver and a wide chisel. Just don’t try moving too fast or you can buckle them.

[gaspen]

I've fit them with automotive adhesive after paintwork

[Cooperman]

I use Tiger Seal to fix them in place. That way it fixes the capping strips and eliminates water/rust from under the strips.

[siaugary]

It was all, the clips, the sealer and the rust 

[sonikk4]

The little bracing angle spot welded to the wing and A panel is original and helps prevent unwanted flexing.