Hi all,
Doing up my front subframe out of the car and I'm seeing differences between the left and right. I think it's hit a kerb or something.
Is there any way of measuring and finding out where it's twisted/ bent?
Pete
Front Subframe Twisted ?
Started by
pete l
, Yesterday, 01:22 PM
4 replies to this topic
#2
PoolGuy
-
- TMF+ Member
-
- 861 posts
One Carb Or Two?
- Location: Bucks
#3
burchy35
-
- Noobies
-
- 116 posts
Mini Mad
- Location: hornsea
Posted Yesterday, 04:18 PM
There is a good chance that one the front tie bar mounts has pulled away from it's weld. Quite common when you have hit a pot hole or kerb.
#4
pete l
-
- Members
-
- 1,398 posts
One Carb Or Two?
- Location: East of France
Posted Yesterday, 04:36 PM
What I'm really after is the top arm measurements, the top arm pickup points. I'm wondering if these have moved
#5
Spider
-
- Admin
-
- 15,179 posts
Moved Into The Garage
- Location: NSW
- Local Club: South Australian Moke Club
Posted Yesterday, 06:15 PM
What I'm really after is the top arm measurements, the top arm pickup points. I'm wondering if these have moved
I tried many different way to measure them, in the end, I made a jig, I just couldn't think of any other way.
Perhaps if you could borrow a new subframe and make some comparative checks against that.
While there seems a perception that they are not all that accurate (I guess because they are a fabricated construction) I would disagree with that. The tolerance for the arms pick-up points is +/- 1/64" (0.4 mm). Also, when doing wheel alignments, you can 'see' this as small adjustments have a noticeable impact.
2 user(s) are reading this topic
1 members, 1 guests, 0 anonymous users
-
DeadSquare
