9 replies to this topic

[Tomf]

I need to take the little bracket out that hold the standard mini seats down. So how do you take it out??? Its the little U bit on the floor.

[Retro_10s]

with an angle grinder, it should be welded onto the floor pan if i remember correctly..

Edited by Retro_10s, 02 January 2007 - 04:35 PM.

[Pooky]

The one in the estate I've been restoring was simlply bolted in. Undid the two nuts for each bracket from underneath the car to get it out.

[Retro_10s]

Hmmm i have seen them bolted on too but i think the came from the factory welded on.

[1984mini25]

Nope they are BOLTED to the car from underneath eater side of the exhaust tunnel, should be 7/16” nuts if I remember correctly.

[Retro_10s]

oooh, my bad. sorry boys.

[Tomf]

Ok thanks everyone ill go have a look fingeres crossed it just boleted from underneeth.

[Jimmyarm]

Make sure you get some spares as there likely to be rusted to buggery under there !

[fikus01]

mine were ok a '93 shell, all came out after i dug out the nuts from the underseal!!

[Tomf]

Your right just two nuts and then it came out