10 replies to this topic

[biggav]

I've had to move the bottle to make way for the fuel reg and nitrous solenoids... i now need a very very small washer bottle to replace the one i have....
Any suggestions?? or shall i just get a drinks bottle with a hose through the top and an inline pump??

[Jimmyarm]

Dont know how strong the standard pump is but perhaps you could fit it in the boot ?

Or even inside the car, then when your driving along and run out of fluid, you can top it up on the fly so to speak

[biggav]

Dont know how strong the standard pump is but perhaps you could fit it in the boot ?

Or even inside the car, then when your driving along and run out of fluid, you can top it up on the fly so to speak

i've already tried to modify my bottle and melted the bottom edges in to try and getit in the gap i have.... no room in the boot as i have 2 tanks and a great big nitrous bottle in there!!!

I'm going to have to try and find a stronger washer pump.

[The Matt]

Fiat panda, early one. They are a bag instead of a bottle! They fit around the stuff that's in the way then!

[wolfie]

i use a fruit shoop bottle

[The Matt]

Like this

[biggav]

just went a got a little water bottle and an inline pump, just going to cram it in wherever it'll fit and remember to top it up after every journey... also got a blade fuse box to fit behind the dash for the fuel pump, nitrous and lighting kit.

[cooper_shaz]

I had trouble getting a washer bottle for a clubman I restored Here is it.
Was booked in for an MOT and washer bottle had not arrived, so..

A Lucozade bottle with an inline pump from Halfords and secured with a hose clip did the job...

Looked cool too...!! hahaha

[Big_Adam]

Seen a few washer bottles in the boot, what they did with twinpoint mini's.

Why not stick the stock fat bottle in the rear bin.

[biggav]

Seen a few washer bottles in the boot, what they did with twinpoint mini's.

Why not stick the stock fat bottle in the rear bin.

i have enough trouble keeping the damp out of there!!!! plus the convertible roll bar will have to weld in there. I have the small bottle now and int going in the turret on the drivers side next to the brake servo!!!

[The Matt]

Seen a few washer bottles in the boot, what they did with twinpoint mini's.

Why not stick the stock fat bottle in the rear bin.

i have enough trouble keeping the damp out of there!!!! plus the convertible roll bar will have to weld in there. I have the small bottle now and int going in the turret on the drivers side next to the brake servo!!!

Sounds good to me