I was wondering if the bmw k conversion fits the 998 A+ engine.
Bmw K100 Head
Started by
charie t
, May 29 2008 10:09 PM
5 replies to this topic
#1
charie t
-
- Members
-
- 3,153 posts
Up Into Fourth
- Location: South Leicestershire sticks
- Local Club: wreake mini wanderers
Posted 29 May 2008 - 10:09 PM
#2
mini93
-
- Members
-
- 8,615 posts
He's just too casual!
- Location: Warwick
- Local Club: Medievil minis of Warwickshire
Posted 29 May 2008 - 10:18 PM
sorry to ******* and moan, but a search would reveale all...in short it might well be able to work, but a hella lot of work is required and a big over bore with offset bore also
#3
Sam Walters
-
- Members
-
- 2,765 posts
Up Into Fourth
Posted 30 May 2008 - 08:08 PM
i need to finish my shell and get saveing then.
#4
level7
-
- Noobies
-
- 108 posts
Mini Mad
Posted 31 May 2008 - 12:12 PM
there should be no problem fitting it to a 998, the first ever was an 850 details can be found here http://www.lojomo.com/i need to finish my shell and get saveing then.
#5
mini93
-
- Members
-
- 8,615 posts
He's just too casual!
- Location: Warwick
- Local Club: Medievil minis of Warwickshire
Posted 31 May 2008 - 12:15 PM
its all about the bore spacing and bore width with a 998 there different to 850
850 and 998 are not the same bores!
go have a read of miniboo's project thread, its all inthere the reasons as to why it isnt as much of a direct fit than the 1275's
850 and 998 are not the same bores!
go have a read of miniboo's project thread, its all inthere the reasons as to why it isnt as much of a direct fit than the 1275's
#6
miniboo
-
- Members
-
- 9,327 posts
Lord of Original Thinking
Posted 31 May 2008 - 06:40 PM
yep it is a lot of work. i havent touched my engine for a while now but hope to do some work on it this weekend so i can get the pockets machined in teh pistons. although i am tempted to just go and get a 1275 block!!!
1 user(s) are reading this topic
0 members, 1 guests, 0 anonymous users
