Looks like a locator tab for a sensor maybe?
O ring is 33mm by 2mm thick best I can measure it, suspect from the gearbox gasket set?
Car is Mpi.
Posted 18 January 2021 - 03:50 PM
Looks like a locator tab for a sensor maybe?
O ring is 33mm by 2mm thick best I can measure it, suspect from the gearbox gasket set?
Car is Mpi.
Posted 18 January 2021 - 03:52 PM
Edited by bpirie1000, 18 January 2021 - 03:53 PM.
Posted 18 January 2021 - 04:00 PM
Hope it is not the gearbox/engine o ring,might cause problems with oil pressure,Good luck,Steve..
Posted 18 January 2021 - 04:02 PM
Yes, rocker tab so not needed as new set on, that's good thank you!
Not no.35 seal that's smaller and thicker and I know it's in.
I think now having searched through minispares it might be the gearbox metal plug at the base which I know I put one in there so not sure why there would be more than one in my kit though. It was 2 years ago the box was built so hope my memory serves me well!
Edited by PiG, 18 January 2021 - 04:04 PM.
Posted 18 January 2021 - 04:04 PM
Posted 18 January 2021 - 04:04 PM
Edited by bpirie1000, 18 January 2021 - 04:18 PM.
Posted 18 January 2021 - 04:05 PM
Posted 18 January 2021 - 04:06 PM
Good luck.....
Normally i find my kidsmput extra bits in my boxes....
just to confuse the hell outta me so getting good at this guessing game..
yes, that could well be the case here too!
Posted 18 January 2021 - 04:09 PM
Looks a bit bit thin section and large ovetall diameter for the box to block seal doesn't it?
What about the distributor seal?
http://minispares.co...px?1~10~85|Back to catalogue
Thank you, possibe it was in my engine gasket set, not needed for mpi
Posted 18 January 2021 - 04:46 PM
If it is from the gasket set, it is probably the seal for the bell crank pivot pin, #27
http://www.minispare...ive.aspx?1~4~42
I don't change these unless there has been a known leak.
Edited by GraemeC, 18 January 2021 - 04:47 PM.
Posted 18 January 2021 - 05:16 PM
Yes, rocker tab so not needed as new set on, that's good thank you!
Generally still needed or your shaft can rotate and you lose the oil feed to the rockers not to mention the grub screw having conversations with the valve train.
Posted 18 January 2021 - 05:22 PM
Yes, rocker tab so not needed as new set on, that's good thank you!
Generally still needed or your shaft can rotate and you lose the oil feed to the rockers not to mention the grub screw having conversations with the valve train.
Good to know, thank you for that.
Posted 18 January 2021 - 06:35 PM
0 members, 0 guests, 0 anonymous users