Community Status Updates
Abimini
The time has finally come to fit the engine, but struggling!! It is an auto to manual conversion with the auto subframe, has anyone got a thread already for this build??
May 25 2014 07:40 PM
-
M J W J
You need to use the rubber mount from under the radiator from the auto engine as the hole spacing is different on the sub frame that side compared to a manual and between the engine mount and the clutch cover you will need to fit a 3/8" thick packer as an auto's sub frame is wider than a manuals
May 25 2014 10:31 PM -
Abimini
Probably should have mentioned, I have the conversion engine mounts... Does the above still stand?? Thanks for the reply
May 26 2014 07:26 AM -
M J W J
If you have the conversion mounts then I assume not but I didn't use them when I did the conversion so I can't tell you. The only other thing you will need to do is connect the inhibitor wires together. The rest is the same as a manual. Just bolt the bits in place
May 26 2014 08:14 AM
This status update has reached the maximum number of replies allowed
