6 replies to this topic

[danrock101]

Cooper S (aeg 521) rod bolts ARP
cooper S big end +20 vander bearings
maniflow 2" exhaust

[tieclubbyestate]

i have this if your intrested i think its 1.75 though its good condition just surface rust from where its been sat
looking for £100 manaflow twin

Edited by tieclubbyestate, 16 April 2011 - 06:11 PM.

[danrock101]

needs to be a large bore, same as this http://www.theminifo...howtopic=179838

[philc]

needs to be a large bore, same as this http://www.theminifo...howtopic=179838

what is your engine spec?

[danrock101]

sorry this is copied and pasted from my excel lol
upgrade
Gearbox
S/C
minispares x pin
S/C drops minispares
3.7 FDD
KAD quickshift

Clutch
Orange diaphram
rally plate
ulralight flywheel
lightend backplate
9 Straps
Uprated bolts


Engine
MED 84mm worked crank Billet crank
Forged omega pistons 73.5mm
Centre main strap
Cooper S rods H beam


Cam
MD296 SP
Belt drive
Standard Pressed steel rockers
Standard cam followers


Head
MED 36/31 Full race 38/31
ARP BOLTS

Exhaust
Maniflow LCB big bore
Maniflow 2”


Carb
Weber 45
38mm chokes
Pipercross air filter
5.5” alloy inlet manifold
Pressure regulator
Facet Red top


Ignition
Megajolt

some of it's changed, only not got the gearbox, crank damper and exhaust now I belive,

[philc]

i had a very similar spec, put the 2" on, lost loads of torque, put 1.75 on worked a treat, however this will be determined at the rollers. however i am no expert I can only pass on my experiences

[tieclubbyestate]

offer still stands;)