I've completed the hardest stages of building my main shaft - quite impressed that I'm not searching my garage floor for tiny springs and plungers!
Now I'm up to putting the synchro hubs back together. I've worked out the 3rd / 4th hub but I'm just a little stuck on the way the 1st / 2nd gear synchro hub is put together. I've paired the two pieces up but I'm unsure of which way round it goes.
I've compared it against pictures of the internet but I'm still not 100% sure.
Any ideas?
Thanks in advance,
Ian
Picture 1
image.jpg 60.02K 14 downloads
Picture 2
image.jpg 64.88K 13 downloads
Edited by Smackfiend, 15 June 2014 - 08:51 AM.