41 replies to this topic

[hotroder69]

Here's my inside. I made my own floor boards and tunnel so I can run lines to the turbo and intercooler.

Attached Files

•  IMG_0623.jpg   47.75K   5 downloads

[megamini_jb]

This is awesome!

[hotroder69]

Thanks. Doing the best I can. Any help would be appreciated.

[hotroder69]

I had to change up the exhaust to clear the air conditioning compressor.

Attached Files

•  D4CC4B3F-C529-4653-AB15-EACAF79E8591.jpeg   37.15K   2 downloads

[hotroder69]

I’m having a time trying to figure out if a newer 2 speed round wiper motor with the installation kit would fit my Mk1 mini.

any ideas?

 

Thanks 

Charlie

[hotroder69]

[attachment=209041:fourm mini.jpg

 

Little more work done.           

       

Attached Files

•  fourm mini.jpg   437.81K   2 downloads

[hotroder69]

 Fourm mini1.jpg   94.48K   2 downloads

 

Coming along slowly.

[hotroder69]

Finally got the compressor installed after some machine and grinding.

 

 fourm mini2.jpg   97.91K   2 downloads

[Ethel]

I’m having a time trying to figure out if a newer 2 speed round wiper motor with the installation kit would fit my Mk1 mini.

any ideas?

 

Thanks 

Charlie

I'm sure you could make one fit. 

 

 The parts are different, but both incarnations are self contained and it's the same windscreen. http://www.somerford...page=page&id=81

 

It's a popular design for bespoke set ups as it very configurable by just altering the rack tubes

[mini-mad-mark]

If you can do all that you have done so far, working out a round wiper motor from a square will not be too difficult for you 

[hotroder69]

 intake before.jpg   61.3K   0 downloadsThanks for the comments. Sorry I haven't gotten much done lately. I finally got the intake ported from when I cut an ince out of it.

Attached Files

•  intake after.jpg   77.08K   1 downloads

[hotroder69]

 shifter.jpg   67.56K   0 downloadsI also installed the shifter and cables.

Edited by hotroder69, 22 September 2020 - 08:55 PM.

[hotroder69]

Well I haven't gotten much done but, I did finish my front end alightment stoppers. Only problem I see is I made two left handed stoppers.

Attached Files

•  IMG_8147.JPG   37.12K   0 downloads
•  IMG_1223.JPG   51.3K   0 downloads
•  IMG_8517.JPG   40K   0 downloads

[PORKPI626]

How wide and tall is your tunnel?

[hotroder69]

It is the same as the front and is 9 1/2" or 241.3 mm