20 replies to this topic

[miniboo]

buy the one from machinemart Big Adam. that is the one that won the test i believe

[Big_Adam]

http://www.machinema...asp?p=040212609

that one?

[miniboo]

no this one

http://www.machinema...p...=2074&g=111

[Big_Adam]

cheers man, have to make a trip up to norwitch sometime during the week then.

[998dave]

yeah, but i don't know if their C**p or not, rather go by a decent rating that a cheap price.

did look at a draper one bloody hell it cost a packet. then i looked at a snap-on one. put the price in perspective quickly.

Mine's a snap-on one! neurgh! Lol, so's my ratchet, a breaker bar, and one socket (long 9/16th's one for cylinder head nuts)...

I use cheap ones at work though, and they're just as good to be fair... Just not quite as sturdy,

D

[Total Richie]

Halfords 60-300Nm & 8-60Nm


These have been really good for me, did previously own a cheap one and after a a few uses it lost it's calibration resulting in me incorrectly tightening half shell bearings, which then resulted in damage to my RS turbo lump, which was nice.

Attached Files

•  TW2.JPG   156.12K   3 downloads