Tomorrow I have an appointment for the Technical Inspection of the Vehicle (M.O.T). With these two threads in bad condition... I don't think it will pass the test.
Thanks a lot Cooperman.
Without Thread
Started by
PACINO
, Nov 27 2020 07:56 PM
18 replies to this topic
#16
Posted 29 November 2020 - 03:39 PM
#18
Posted 02 December 2020 - 09:38 PM
Groove goes inboard, against the radius arm pin shoulder. The rubber seal should go around the outer circumference of this washer
Edited by cal844, 02 December 2020 - 09:39 PM.
#19
Posted 03 December 2020 - 07:58 AM
Groove goes inboard, against the radius arm pin shoulder. The rubber seal should go around the outer circumference of this washer
Cheers Cal
1 user(s) are reading this topic
0 members, 1 guests, 0 anonymous users