I goofed up and didn't measure where the floor X member was exactly located on the floor. Now it's time to weld in a new one and I am not quite sure where it should be centered. Hope someone can help me out. It is a rod change X member, so if someone can take a measurement like the pic., then I can install it. I you have a better idea for alignment I am all eyes and ears.
Thanks in advance for the help.
PS I was measuring from the center of one of the two holes the the edge of the crossmember, currently it looks to be about 25mm.
Edited by Minirook, 17 February 2022 - 08:16 PM.