8 replies to this topic

[Minirook]

I goofed up and didn't measure where the floor X member was exactly located on the floor. Now it's time to weld in a new one and I am not quite sure where it should be centered. Hope someone can help me out. It is a rod change X member, so if someone can take a measurement like the pic., then I can install it. I you have a better idea for alignment I am all eyes and ears. 

 

Thanks in advance for the help.

 

PS I was measuring from the center of one of the two holes the the edge of the crossmember, currently it looks to be about 25mm.

 

Edited by Minirook, 17 February 2022 - 08:16 PM.

[MacGyver]

Might get that for you tomorrow evening on my way home, but here's a free bump while you wait. 😁

Ben

[Minirook]

Thanks!

[MacGyver]

Darn... Completely forgot...
Got ambushed by the in-laws where the car is (currently waiting in there garage), took me an hour to manage to escape and forgot to get the measurements. Sorry.

Going back tomorrow afternoon, will grab it then.
Unless someone here gets it beforehand... 😐

Ben

[Minirook]

Thanks Ben. 

[MacGyver]

If you need any other measurements, please let me know. 😉
It's a 99 mpi shell, just has the front wings bent, all the rest is straight. 😁

[Minirook]

That should be it for now. Thanks

[MacGyver]

 _20220227_124513.JPG   55.39K   2 downloads
Same place as yours
 _20220227_124550.JPG   61.63K   0 downloads
From the back side of the cross member
 _20220227_124608.JPG   29.29K   2 downloads
From the rear bins to the back of the cross member.
Hope this will do?

Ben

[Minirook]

Many thanks Ben! Just what I needed.