6 replies to this topic

[Lucas1988]

Hi Everyone

 

I have a 1220 engine which i brought to fit in my car but I've ended up going for a custom built motor to enable me to run a turbo so this needs to go.

 

Especially with it currently sat at my parents in their garage in the way. 

 

I brought it because it was originally an 1100 motor that has been over bored. I stripped it down to check it all over as i know it had ran previously but i didn't want to just assume it was fine before we re-built it again, I decided to go a different route with the engine build and so this became surplus to requirements.

 

Included is block, crank, pistons, rods and a big red tub of all the little bits i removed off it.

 

no gearbox or head as i sold those soon after i brought it as i was going to be using a 12G940 head i already had and a straight cut box

 

photos sent on request

 

grab a bargain

 

£300

[Lowestoftmodder]

Could you put up some pics please?

[DeadSquare]

If you have a Vernia, as the head is off, please could you measure the bore / stroke ?

[PoolGuy]

That should make a nice engine for someone.

[whistler]

I'm guessing it's a 68mm bore with Keith Calver or Graham Russell flat top pistons. Hopefully it was offset bored. 

[Lucas1988]

If you have a Vernia, as the head is off, please could you measure the bore / stroke ?

sorry i don't and I'm not at my parents to measure anything

 

only got photos, i can send them through whatsapp or email. pm me and we can sort photos

[Lucas1988]

Could you put up some pics please?

i can send photos via whatsapp or email let me know via pm