I had this problem when I wired the front indicators in series (repaired the section of harness). What confused me was when testing there was 12v but it wouldn't flash. I added a short bit of wire to the back of the bulb holder to make them parallel rather than two wires into 1 connector on the bulb holder and that fixed it.
Might not be the issue but it took me a while to figure it out!
Front Indicator
Started by
Trickyt66
, Apr 14 2024 11:58 AM
17 replies to this topic
#16
ThermalEvent
-
- Noobies
-
- 123 posts
Mini Mad
- Location: West Suffolk
- Local Club: n/a
Posted 15 April 2024 - 09:21 PM
#17
Trickyt66
-
- Noobies
-
- 8 posts
Just On Tickover
- Location: West wales
Posted 16 April 2024 - 08:53 PM
Thanks all, I'll be back on it next few days so I'll try the various suggestions....fresh eyes and all that !
#18
Trickyt66
-
- Noobies
-
- 8 posts
Just On Tickover
- Location: West wales
Posted 02 May 2024 - 10:54 AM
So after a wiggle of the wires from the harness to the back of the indicator I have a working flashing bulb ! I can only think a dodgy connection was to blame after re aligning the bonnet previously. With that said I still have no hazards so need to work from the switch back. Thanks again everyone for the replies, suggestions and input, much appreciated
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users
