what do you do for the front driveshafts as they arnt long enough to meet in the middle? ( not that it make a difference if they did i suppose)
do i assume you have 1 long one made up from...... somewhere?
cheers
mic
front driveshafts
Started by
mic
, May 09 2007 04:34 PM
3 replies to this topic
#2
ed4ran
-
- TMF+ Member
-
- 2,849 posts
Cadwell Event organiser
- Location: Stoke On Trent
Posted 09 May 2007 - 07:18 PM
Why? If the engine is in the rear you just remove the driveshafts and leave the outer CVs.
#3
Renessy
-
- Members
-
- 306 posts
Speeding Along Now
- Local Club: minisevenclub Holland
#4
koss
-
- Members
-
- 1,399 posts
One Carb Or Two?
- Local Club: The Greenbank working mens social club
Posted 09 May 2007 - 09:15 PM
Well I done what rover did when they built the MGF. Just hollowed out the cv joint.
Mounted the magnets for the speedo on the outside of the cv. Worked fine.
They are pretty hard to machine unless they are annealed then re hardened.
Mounted the magnets for the speedo on the outside of the cv. Worked fine.
They are pretty hard to machine unless they are annealed then re hardened.
1 user(s) are reading this topic
0 members, 1 guests, 0 anonymous users
