6 replies to this topic

[ministudio2]

how the hell do i get this out lol

Attached Files

•  DSCF1484.JPG   673.5K   9 downloads

[ministudio2]

please help lol cant seem to find out how it comes off its holding me up now

[dklawson]

It's been a while, but I believe all that's necessary is to undo the big nut shown on the left of your picture and then push the shaft over towards the right. There should be a large flanged head on the right end which is keyed to prevent the shaft from turning and/or pulling through when the nut is tightened.

[ministudio2]

any certain ways do i have to hit it the nuts of but still no joy

[Dan]

It'll be siezed into the bottom arm bushes, can be really hard to remove. Lots of release spray and leave a G-cramp wound up on it over night to keep the force on is the answer. It pulls through away from the nut, towards the large end.

[ministudio2]

so a good wack on the end with a sledge hammer should do it??

[ministudio2]

sorted sledge hammer done the job