8 replies to this topic

[Lucas-Minster]

Hi, I've had this bonnet release kit hanging around the garage for months now and havn't got round to fitting it yet...does anyone know where to start? any help would be very much appreciated!!

thankyou!

Luke

[Bungle]

the front

[frankiebateman]

At the bonnet

[Lucas-Minster]

nicee...just wanted to know how to connect it..

[Bungle]

open the bonnet and remove the catch on the slam panel (2 bolts) fit the new catch in its place

run cable from this catch around the engine bay into the car

fix bracket under dash and mount pull

check it works

job done

[Globule]

Im my experience, keep the grille off if possible as if the catch feels like being annoying, then the bonnet wont open and the screws at the top wont come off when the bonnets closed!

[Lucas-Minster]

ah...thanks guys..wer can i put the pully thingy inside the car?...(duc tape to the dash board ?...lol)

[Bungle]

mines under the dash between the steering column and the little switch panel on the right hand side

[taffy1967]

I think you're going to have to drill a hole through the bulkhead for the cable though?