1203 replies to this topic

[mighty mini jack]

Tom, loving all these carbon bits!!

Getting there!

*COUGH* Ben *COUGH*

[mighty mini jack]

[tomgale]

Yes there should be a spacer

(From what I can remember )

oh shiiiiiiiiii........... so thats what that thing is? how important is it?

[HARBER07]

[HARBER07]

Yes there should be a spacer

(From what I can remember )

oh shiiiiiiiiii........... so thats what that thing is? how important is it?

Fairly important by the looks of things. (I wont mention that I found the spacers in the box the wheel bearings came in )

[sweetser]

You eeejit!!! lol not exactally a big box either

[tomgale]

Yes there should be a spacer

(From what I can remember )

oh shiiiiiiiiii........... so thats what that thing is? how important is it?

Fairly important by the looks of things. (I wont mention that I found the spacers in the box the wheel bearings came in )

if i havent tightened up the hub nuts, will the oil seals come off easily? this has explained the mystery of the very important looking thing which has been sat on my desk for a while......

[HARBER07]

Should come off OK with a wide flatblade scrwdriver, But you shouldn't need to remove the oil seal? I think the inner race should just drop out.

[tomgale]

i was planning to do it from the hub side, because i cba to take the hub of the subby, but i might be able to get at it from that side, i left the subframe pecariously balanced in an extreemly awkward location so i can only realy reach the flange easily, you know because i enjoy the challenge. anyway stopping the spammage now.

[HARBER07]

I dont mind spam!

Edited by HARBER07, 26 May 2010 - 09:48 PM.

[HARBER07]

Chiken chow maine

[mighty mini jack]

terry the turtle on toast!

[HARBER07]

Feast on my beast

[mighty mini jack]

Been there, done you!

[HARBER07]

*woman of ill repute*!