Jump to content


Photo
- - - - -

Help Needed, Garage Choc-full Of Spares


  • This topic is locked This topic is locked
62 replies to this topic

#31 alicetheauto

alicetheauto

    One Carb Or Two?

  • Members
  • PipPipPipPipPipPipPip
  • 1,222 posts
  • Location: Leicester
  • Local Club: Rusty Nuts Minis, Leicester

Posted 02 September 2010 - 08:58 PM

Also, that "trick axle" looks like a beam axle. It is a replacement for the rear subframe which is often to allow coilover suspension dampers to be used. It is also MUCH lighter than a conventional subframe. Value is very dependent on the quality of the subframe and its condition. It looks like there are at least 2 rollcages in that lot as well. The engine which is pictured in the dark, under the car, appears to be an a-series as opposed to the later a-plus, because it has the long arm on nthe clutch. Look around for brake setups in the garage, if you find any front brake discs on driveshafts, measure and see if they are 7.5" or 8.4" diameter. If they are 7.5", then a second hand pair of the discs with hubs and brake calipers is worth a couple of hundred quid a go.... I would almost expect a couple of sets of those in that garage.
You have probably got £3k+ of parts in that lock-up, well done.

#32 Nic

Nic

    Formally known as jonesy!

  • Members
  • PipPipPipPipPipPipPip
  • 1,218 posts
  • Location: Thame, UK

Posted 02 September 2010 - 10:23 PM

you have a genuine R/h cooper S fuel tank, most of these go for £200 - £250 on ebay.

#33 998dave

998dave

    998cc's Of Dave Goodness

  • TMF+ Member
  • PipPipPipPipPipPipPipPipPip
  • 4,566 posts
  • Name: Dave
  • Location: Essex

Posted 03 September 2010 - 11:26 AM

16 I Would love to know what this bonnet is from, its the same size as a mini bonnet.
Posted Image
Posted Image


Simple. Its off a Riley elf / Hornet.


Fancy selling it? Where are you?

#34 lindy119

lindy119

    Super Mini Mad

  • Noobies
  • PipPipPipPipPipPip
  • 514 posts
  • Local Club: looking for one!!

Posted 03 September 2010 - 11:31 AM

16 I Would love to know what this bonnet is from, its the same size as a mini bonnet.
Posted Image
Posted Image


Simple. Its off a Riley elf / Hornet.


Fancy selling it? Where are you?



Anyone else think that that bonnet could be used for a 7/8 port head? Or will it not fit a mini?

#35 lindy119

lindy119

    Super Mini Mad

  • Noobies
  • PipPipPipPipPipPip
  • 514 posts
  • Local Club: looking for one!!

Posted 03 September 2010 - 11:32 AM

You have so much cool stuff!! How many minis was he planning on building!!?? :thumbsup: An army??!! ;D

#36 bltrdly

bltrdly

    Stage One Kit Fitted

  • Noobies
  • PipPipPip
  • 80 posts

Posted 03 September 2010 - 11:56 AM

You have so much cool stuff!! How many minis was he planning on building!!?? :thumbsup: An army??!! ;D


Haha, thats the funny thing, its all for one mini!

Ive just got a lot more stuff out today, im going to put pictures up later today.

#37 bltrdly

bltrdly

    Stage One Kit Fitted

  • Noobies
  • PipPipPip
  • 80 posts

Posted 03 September 2010 - 11:56 AM

Fancy selling it? Where are you?



Manchester. Ive got 2 hornet bonnets at the moment, ill get pictures of both up

#38 bltrdly

bltrdly

    Stage One Kit Fitted

  • Noobies
  • PipPipPip
  • 80 posts

Posted 03 September 2010 - 11:59 AM

Can anyone help me identify the clocks that ive just pulled out the garage. One goes to 90mph, the other is 130mph. Im guessing 90 is a cooper, the 130 is a cooper s?

#39 Paulo666davey

Paulo666davey

    Passed Test

  • Noobies
  • PipPip
  • 34 posts

Posted 03 September 2010 - 12:21 PM

16 I Would love to know what this bonnet is from, its the same size as a mini bonnet.
Posted Image
Posted Image


Simple. Its off a Riley elf / Hornet.


Fancy selling it? Where are you?



Anyone else think that that bonnet could be used for a 7/8 port head? Or will it not fit a mini?


they cane be used for a 7/8 port mini, i bought a bonnet just the same but it was fibreglass basically it was a copy of that bonnet with no hole in the front and you just cut a hole in the front to your requirements,
the guy from pl minis had one on his mini.
http://www.plmini.co...76_dhr_side.jpg

#40 Paulo666davey

Paulo666davey

    Passed Test

  • Noobies
  • PipPip
  • 34 posts

Posted 03 September 2010 - 12:24 PM

Can anyone help me identify the clocks that ive just pulled out the garage. One goes to 90mph, the other is 130mph. Im guessing 90 is a cooper, the 130 is a cooper s?


the cooper s one should have gear selection marks if i am right, they are a yellow/orange colour i think, used for i identification of when to change gear if you didnt have a rev counter

#41 joe90gt

joe90gt

    Mini Mad

  • Members
  • PipPipPipPip
  • 288 posts

Posted 03 September 2010 - 12:38 PM

Naa , its all worthless , I 'll take it of your hands for quid

#42 maggies_minder

maggies_minder

    TMFs New official Spamster

  • Members
  • PipPipPipPipPipPipPipPipPip
  • 4,393 posts
  • Location: i dont know
  • Local Club: sutton coldfield mini club

Posted 03 September 2010 - 12:47 PM

as many have said your on a little goldmine,

do some research before selling to make sure you get what everything is worth and dont get done over,

good luck bud :thumbsup:

#43 bltrdly

bltrdly

    Stage One Kit Fitted

  • Noobies
  • PipPipPip
  • 80 posts

Posted 03 September 2010 - 12:51 PM

as many have said your on a little goldmine,

do some research before selling to make sure you get what everything is worth and dont get done over,

good luck bud :thumbsup:

Thanks mate :- A few people have also told me to take my time, at the end of the day i should sell it at my own pace and when im ready ;D

Just uploading pictures of todays find, will post asap.

#44 E-Tizzle

E-Tizzle

    One Carb Or Two?

  • Members
  • PipPipPipPipPipPipPip
  • 901 posts
  • Local Club: Essex Mini Club

Posted 03 September 2010 - 12:55 PM

if that door ( i assume its one and has been turned over in second picture) is in good condition all over, which it could be as been in garage for 15 years. then it will be worth a lot.

doors go for stupid money, top condition one, maybe £200 or more.
you will need to check it over first tho, especially at the bottom for signs of rust.

#45 bltrdly

bltrdly

    Stage One Kit Fitted

  • Noobies
  • PipPipPip
  • 80 posts

Posted 03 September 2010 - 01:02 PM

Ok the pictures have finally finished uploading, so here they are:

The 2nd hornet bonnet, not in the best conditions:

Posted Image
Posted Image

So many dials and clocks!

Posted Image
Posted Image
Posted Image
Posted Image
Posted Image
Posted Image
Posted Image
Posted Image

Group photo!
Posted Image

2 boxed shock absorbers.
Posted Image

Posted Image

(This one (The black one) was in its own special little leather bag.But I cant figure out why my dad would separate and take care of this one above all the others, any ideas?)
Posted Image

Posted Image
Posted Image
Posted Image
Posted Image
Posted Image


Theres two of these:

Posted Image




1 user(s) are reading this topic

0 members, 1 guests, 0 anonymous users