something to read -
http://www.minimania...t_problems_1227
they seem to torque 45 oiled stud & 50 dry - no higher
I torque to 45 - (studs are oiled) & check after 1 heat cycle 45 Lbf
when I recheck , I don't slacked the bolt & re torque - I only check that the nut is at the set torque
only problem I get is slight weep on copper gaskets -
so I usually run engine dry , for first few mins to cure varnish on gasket - how I was taught to do it
Edited by sledgehammer, 11 January 2015 - 03:08 PM.