1 reply to this topic

[[email protected]]

Hiya everyone, i,ve recently bought 3 pistons and conrods and although im sure i know what it is i cant find one the same for sale online? Any ideas would be very much welcomed as im going to take a block to be bored on tuesday and ideally id like to find one in the next week or two; ill take the 3 i have on tuesday and can send one on to them when i find one (if... i guess i should say - fingers crossed!)

It is a 73.5mm piston and it has 'mega' written on it. it also has '10032' or '10037' after the word mega.

The piston top has a border around the outer edge about 5mm wide and then the whole ctr is about 4mm lower than the outer rim. in the very center is a tiny dish about an inch round and just 1 or 2mm deep.

The conrod is an aeg177.

 

I want to fit these to an mg midget crank but there was only 3 in the set so i need to find one more of each.

 

Would love your help if you can.

 

Many thanks... Stu

 

i just set up onedrive thingy, will see if thisworks...?

<iframe src="https://onedrive.liv...AJOEIKGn2bVyDG8" width="320" height="240" frameborder="0" scrolling="no"></iframe>

 

or

 20151024_124422.jpg   51.25K   2 downloads

 20151024_124444.jpg   44.16K   6 downloads

 20151024_124529.jpg   48.71K   2 downloads

 

 

 

[ACDodd]

That's an omega piston with a custom dish machined in. I would be very sure of the condition of the others before trying replace just one. This one piston would then need to me custom machined to match the other 3.

 

AC