#1
Posted 16 May 2020 - 10:55 AM
TIA
#2
Posted 16 May 2020 - 10:57 AM
Put something through the hole and try to move the holder.
#3
Posted 16 May 2020 - 10:59 AM
Try putting the piston in a saucepan (other utensils might be available) with very hot water. Different materials expand at different rates. Sometimes the optimum time to try the removal is as it all cools down.
Edited by whistler, 16 May 2020 - 10:59 AM.
#4
Posted 18 May 2020 - 10:09 AM
Nicklouse: Tried that but there is only a slot .. the base of the needle holder is below the hole so nothing to push down on ..
Whistler: Will try that this week when SHMBO isn't around so can't see my boiling up engine parts in her new saucepans!
#5
Posted 20 May 2020 - 02:05 PM
Got it out .. but ended up with brute force ..
The needle holder must have been splayed but over-tightening .. as it just refused until I wrapped the needle in tons of masking tape and gentle levered it out with pliers .. heating didn't work, and a screw driver just made it rotate slightly ...
It wasn't even the needle type I need so that was a waste of time really .. had I know that ...
But many thanks for the suggestions ..
Also tagged with one or more of these keywords: engine
Mini Technical Sections →
Problems, Questions and Technical →
Piston Rings - A-Series 998 Engine - Help RequiredStarted by WanaGo , 18 Apr 2024 engine |
|
|
||
Mini Technical Sections →
Problems, Questions and Technical →
Exhaust Choice 45Dcoe - Rc40?Started by lachlan1275gt , 13 Apr 2024 engine |
|
|
||
Mini Technical Sections →
Problems, Questions and Technical →
1071 Main Bearing Caps.Started by 246jaenick , 02 Apr 2024 engine |
|
|
||
Mini Technical Sections →
Problems, Questions and Technical →
Misfire - Ignition Fault Or Fuel Problem?Started by derekaka2sheds , 01 Apr 2024 electrical, engine |
|
|
||
Mini Technical Sections →
Problems, Questions and Technical →
Which Rocker ArmsStarted by mark the diver , 30 Mar 2024 engine |
|
|
1 user(s) are reading this topic
0 members, 1 guests, 0 anonymous users