9737 replies to this topic

[steeley]

+1 above I have the mini spares loom and centre clocks is it fairly straight forward

[FlyingScot]

Opened the garage checked it still there.....closed the door again.
Persisting with rain the last days, no chance to drive her.....

FS

[spiguy]

FS - Ben convinced me to take the mini to knockhill on Sunday to watch a guy we know autotesting, and watch the hot hatch track action too. Wow... would have been better having a boat coming home! That said, apart from a bit of steaming up, the car never missed a beat despite torrential rain. There was actually a surprising number of modern casualties littering the hard shoulders!

[FAZ]

fitted new clutch, drove it, realised the clutch cant engage because the fulcrum on the arm isnt right, needs spacing out on the thrust bearing

 

removed rear radius arm for exchange

[Mon_Papillon]

Continued to sort (read clear) the crap in my garage in anticipation for mini arrival! Due to see a potential winner on Friday morning - can't wait!

[Zach P-D]

Bought a new stage 1 maniflow system and now I am looking for a inlet manifold

[David128]

Fitted Vacuum Gauge and am only reading about 14" and funnily it increases when I give it some gas.. I wonder if its my leary cam???

[chrissyb007]

full service done  just gotta sort timing and mixture out now

[Rocket.]

Fitted the wiper motor

[BronkoMini]

Fitted a new throttle cable ready for mini club run tomorrow and filled her up:

[mina08]

Ordered a ton of parts, put the roof and bike rack on, keep looking at it through the window.

[need4speed]

I started preparing to drop the front sub-frame out. There's not much holding it in apart cables, pipes and the exhaust. I'm using spanners I haven't touched for decades!

[David128]

Welcome to my world

[cp2708]

Fitted new Dashboard, pleased with it. Oil temp sender in sump plug seems to be infuluenced by wind cooling on fast roads though :-(

Attached Files

•  image.jpeg   64.86K   13 downloads

[minifreek1]

Attempted to fit the ultimate engine steady, but couldn't decide where it fitted to the bulkhead...

 

Fitted front polybush to the top engine steady, but couldn't undo the rear bolt to replace that bush .....

 

It started to rain, so packed up me spanners and went inside to sulk....