919 replies to this topic

[nicklouse]

Mm today was adding the bits of the inner wings that were missing.
 image.jpg   72.87K   27 downloads
And blocking off the air vert holes.
Put the rear beam in to check clearance.
 image.jpg   60.2K   33 downloads
Some reinforcement to the subframe.
 image.jpg   91.93K   33 downloads
Finished of the seat mounts.
 image.jpg   39.46K   20 downloads
And then there is the issue of the rest wheel arches.
 image.jpg   72.91K   58 downloads
As I don't want to burn the paint off again.

[nicklouse]

Today was interesting.

As I am flattening the bottom of the car if I needed to make some form of brackets that will take the "floor"

First part went well.
 image.jpg   76.33K   54 downloads
Then just layer the rods that will make the "floor".
 image.jpg   102.24K   48 downloads
Then thought I had better check the frame still fits the shell.

Mmmm I might have a problem here.

[jonny f]

this looks great!

[nicklouse]

Right today was refitting the subframe drinking tea, grinding and welding.

Dropped the old front part on and had some Tea.





Round two


Then more grinding and getting ready for blasting and epoxy.

Edited by nicklouse, 09 July 2017 - 11:07 PM.

[nicklouse]

Dropped something of for blasting and epoxying. Collect on Friday. Not the subframe. Just a small bit to see how it comes out.

[nicklouse]

Well went to collect the part. Yep I think they will be doing some more work for me.


Better get the front subframe ready for them.

[nicklouse]

Well today was a day of sorting out a few little things. One thing that I have seen is people struggling with top arm bearing replacement with some really odd suggestions including welding bit to the bearing. I guess this is because people have not cleaned out the old grease first. There is loads of room to get a drift behind the inner face and knock them out.
I use a slightly shaped drift.





Finished off the front subframe. Of to the blasters next week.

[MJWarren]

Are you not lightening the front subframe any? There's a fair chunk of material you can remove and still retain the strength!

[nicklouse]

The car is already 100kg too light for the regs here.

[Gr4h4m]

Looking great

[nicklouse]

Free carpet can't be beat.

[Gr4h4m]

Ooo carpet the garage how cool

[evansisgreat]

That's all looking great, it's such an interesting build. I'll be trying to drift out my top arm bearings after a thoughrough decrease.
That prurple carpet is pure sex by the way.

[nicklouse]

That's all looking great, it's such an interesting build. I'll be trying to drift out my top arm bearings after a thoughrough decrease.
That prurple carpet is pure sex by the way.

note the shape of the tool. it is not a bad photo it is shaped like that and grind a flat end too it.

 

less likely to slip. also on the side with the grease nipple take care that you dont hit it or the hole it is in as they are at about that distance.

[nicklouse]

Tank suport rails in.